[solved] Long and short-range weapons, both on a single unit Options

[KajiTetsushi]

Okay, like this: I happen to remember a game called Warzone 2100. There's a rocket artillery in this game that works in a way that:

• If the enemy is far away (say, middle to maximum range), the rocket artillery will launch rockets in a low arc, like a Tick Tank's gun ballistic.
• If the enemy is up close (in this case, below middle range), the rocket artillery will launch rockets in a high arc, like the Artillery's gun ballistic.

So, I experimented with it. I made two weapons, say,
[227mmLo] and [227mmHi], for low-arc and high-arc ballistics respectively.

Both weapons deal the same amount of damage, use the same warhead, reload in the same rate - everything is the same,
except in certain conditions,
where [227mmLo] has a Range=14, a MinimumRange=6 and Lobber=no
where [227mmHi] has a Range=5 and Lobber=yes.


Result? It didn't work. What the TS engine would do is force the launcher to forever use 227mmLo. I've tried with other methods such as raising damage of 227mmHi so that the game will conclude this weapon is more damaging and hopefully start raising hell when units are up close. Tweaking the warhead didn't help, either. One weapon went only for buildings, the other for everything else.


Correct me if I'm wrong: my understanding of the Primary and Secondary is just a question of which weapon is more useful against what. I mean, I know how to make a Mammoth Tank fire shells on tanks and missiles on infantry RA1 style with the right warhead and damage, but how about this one?

Again, to sum it up, this is about making a unit's weapon behave differently depending on the distance of the enemy from the unit.


Problem solved. Those who are reading can refer to LKO's solution and my correction in the post after that.

This post has been edited by Chris Ichikawa: Jun 27 2010, 08:37 PM

[Bittah Commander]

You made the warhead of 227mmHi do more damage than the warhead of 227mmLo, but also removed MinimumRange=6 from 227mmHi? It seems to me like it'd then always keep using 227mmHi (so it'll then never use 227mmLo at all).

[Lin Kuei Ominae]

"Lo" is the one with the farther range and "Hi" with the shorter, thus "Hi" should replace "Lo" when the enemy is near. His "Lo" and "Hi" refer to the projectile flying height and not the Range.